Search/Navigation:
Related:
SLAC
/EPP/HPS Public
Jefferson Lab/Hall B/HPS Run Wiki
S30XL-LESA/LDMX
HPS 2014 SVT Group C Setup
All operations are from hpstracker in group C.
Operation
!!! Remember to make sure the detector is being cooled. !!!
Basic instructions to take a pedestal run with CODA
To be added.
MPOD Power Map
Table as of 11/17/2014
| GUI FEB ID | Physical FEB | Status | Comment |
|---|---|---|---|
| 0 | L1t | OK | |
| 1 | L2-3t | OK | |
| 2 | L5t | OK | |
| 3 | L6t | OK | |
| 4 | L4t | OK | These should be checked! |
| 5 | L4b | OK | |
| 6 | L5b | OK | |
| 7 | L6b | DIG bad (Y-cable problem?) | |
| 8 | L2-3b | OK | |
| 9 | L1b | Short on AVDD? |
| GUI Flange ID | Physical Flange Board | Status |
|---|---|---|
| 0 | 1 (top) | OK |
| 1 | 2 | OK |
| 2 | 3 | OK |
| 3 | 4 (bottom) | OK |
Reloading PGP card drivers
Typically after a reboot we need to reload the pgp card driver.
$ cd /u1/pgpcard/software/driver_old/
$ ./pgpcard_load
OLD: Take a calibration run with expert SVT GUI
Start the DAQ:
$ cd /u1/software/software_new
$ source setup_env.csh
$ ./bin/frontEndTestGui
Click <read status> and make sure no error is seen. If so, check that the FEB is powered correctly.
Make sure the AxiXadc temperature is ok (50-60C).
Configure with config/FrontEndBoardConfigC01.xml
Click <read status> and check that more registers are found.
Turn on power to hybrids (see below)
Do a hard reset under commands/FebCore/HybridHardReset (current on AVDDP should drop ~100mA).
Click <Write config>.
Do a soft reset under commands/FebCore/HybridSoftReset.
Check that the hybrid currents measured are ok. Sync status for each channel can be seen in register RceCore/DataPath[x]/Synced, 1xf for powered channels.
Test Run SVT Group C Setup
Overview
Content Tools