Table of Conents
Welcome to the interactive map of the first thermomechanical ring prototype at SLAC. You can visit the Cooling Tubes Up map here.
To explore the ring map in interactive mode, use the buttons on the bottom right of the Gliffy diagram macro. They work inline on Chrome; on Safari, you need to enter full screen. Hover your mouse over the image to get the full screen menu option.
Heater ID: Quad, batch | #11 | #12 | #13 | #14 | #X | #16 | #17 | #18 | #19 | #20 | Uncertainty | Source |
---|---|---|---|---|---|---|---|---|---|---|---|---|
Length (cm) | ±30 μm | Heaters.xlsx | ||||||||||
Width (cm) | ±30 μm | Heaters.xlsx | ||||||||||
Thickness (μm) | ±5 μm | Heaters.xlsx | ||||||||||
Resistance when wires first bonded (Ω) | ±0.1 Ω | Heaters.xlsx | ||||||||||
Resistance: mounted on ring, before spray painting (Ω) | Heaters.xlsx | |||||||||||
Mass (g) | ± 0.001 g | |||||||||||
Module thickness at center, measured with micrometers (μm) | ||||||||||||
Wire thicknesses, measured with calipers () |
Heater ID | |
---|---|
Before IPA wash & dry rag polish | |
After IPA wash & dry rag polish | |
Comments |
Heater ID | |
---|---|
Load date | |
Load position | |
Shim testing results | |
Expected glue layer thickness (μm) | |
100-μm shim | |
200-μm shim | |
Glue batch | |
Syringe ID | |
Date dispensed | |
Dispensing | |
Estimated glue mass per star (mg) | |
Averaged mass tests | |
Time elapsed since syringe fully thawed | |
Minutes module held under vacuum (Hold time) |