Run 4 Ds1 average gain corrections

• /reg/neh/home/philiph/cxi/myana/gainAnalysis/hantkeGainCorrections_highCut_cleaned_relative.txt (using signal as a function of intensity)
• /reg/neh/home/philiph/cxi/myana/singlePhotonAnalysis/averagedCorrections_cleaned_relative.txt (using single photon peaks at low intensity)
• images at https://confluence.slac.stanford.edu/display/PCDS/CSPad+analysis+meeting%2C+10+August+11
• these should be sensible for any detector

Run 4 DSD metrology (pre-run) , image

• "There are 4 2x1 sensors that do not work. There is also a single 2x1 slot on one of the PCBs that has a bad connection. So the sensor works, but we can't operate it.
• The inner, beam-side 2x2s have tungsten shields, but only one other 2x2 does. Many of these modules were used during Run3 and so have some radiation damage and chipped sensors." - from Chris

Run 4 XPP metrology (pre-run) , image

• quad order in file is \[0, 3, 1, 2\] from looking at IZM modules - [more info|^CSPAD-XPP-Configuration-Aug10.pptx]

• Mikhail's fits are at /reg/d/psdm/xpp/xpp47712/calib/CsPad::CalibV1/XppGon.0:Cspad.0/
• There are 9 types of files:
  • center/0-end.data
  • center_corr/0-end.data
  • marg_gap_shift/0-end.data
  • offset/0-end.data
  • offset_corr/0-end.data
  • quad_rotation/0-end.data
  • quad_tilt/0-end.data
  • rotation/0-end.data
  • tilt/0-end.data

Run 5 DSD metrology,image (before Q2 rework), configuration

See Mikhail's alignment page, also see here.