You are viewing an old version of this page. View the current version.
Compare with Current
View Page History
« Previous
Version 6
Next »
Intro
Specifications - Laser
Specifications - System
Presentations
Initial Proposals
20-FY242_KA25_PoF_Proposal.pptx
KA25 FY24_Synopsis_PoF.docx
Other talks about PoF
CPAD_2023_Ajib_Paudel (1).pdf
EIC_R_D_2023_Mandal.pdf
Meeting Minutes
Meeting 16 November 2023
Meeting Minutes:
Next Steps:
- Sketch of lab space in 113 (James)
- Ask Ryan about Lab space in building 84 (Sander)
- Contact Mike Wooks for a meeting (Sander)
- Redefine Scientific goals (everybody)
- Verify if it can power 1 reticle (min) and 16 reticles (max) (Alex)
- Contact DUNE at FNAL (Sander)
- Can we/ Will we take a SULI Student? (Caterina)
- Draft of PCB board (Pietro)
Meeting 2 November 2023
Meeting Minutes:
- Marty talked to Michael Woods (Laser Safet Officer at SLAC), and he seems understanding of our need. General recommendations: laser always connected to a receiver, laser in a box,...?
- Mengqing at Nikhef has a set of lasers. A possible collaborator.
- Sander has been to the laser safety event at Stanford.
- We need to think about the system level for safety, and for practical reasons (where to dissipate power in a power-pulsed system). We either have to control the laser, or tune it to deliver the 'average' power that is stored on a capacitor, and regulated with an LDO
- We need to start with a generic system, with LDO, and a set of variable loads (resistors) with a way to monitor the ouput voltage and current, to characterize the system before connectiong it to any real load (ASICS, SiPM).
To Do list:
- Start ES&H Process on laser safety (Sander)
- Literature study on solutions/competitions (Alex)
- create a list of possible laser and diode providers (Alex and James)
- Concept design of PoF board (Pietro)
- Start setting up a lab space (James)
- Reach out to collaborators, with a potential meeting before winter break (Sander and James)
- Keep an eye for relevant talks at CPAD and NSS (everybody)