Here is detailed information for the experimental set-up:
Known Problems:
XTCS Newport Stages
URS150 rotational stage reference but will stall on move. The UTS150 linear stage now works using "default" settings. A lot of time was spent between Christian, Eric, and Nick understanding connection and pin layout flipping throughout the cable routing from controller to stage.
XTCS Filter Wheel
A new air-side DB15 to MForce cable was fabricated and installed today. Instead of a new IOC this device was connected to the user dumb motor patch panel and set up using the "XUV Filter Position" configuration.
The comments on the XTCS cable list for the filter wheel are:
- Beckhoff, not a regular dumbmotor; probably go slightly longer (5-10 cm) but not any shorter. - same as the XUV spectrometer. (So we are using the correct parameters).
The device connects but no motion occurs at the stage.
The XTCS Filter Wheel configuration is:
- MEC:USR:MMS:20 user motor patch panel (Rack PR60)
- Connections from outer flange to patch panel include custom cable and a MForce extension cable.
- Connections from inner flange to bulkhead are in-place DB15 and a DB15 extension cable.
- Using XUV Filter position parameters
Internal XTCS cable pin-out:
Air-side cable pin-out:
MCC Side pin-out from MCC Schematic on the IMS and MForce Motors page:
The remaining ECS Delivery items (if not listed above) are:
Detectors:
- replacement for GIGE4
- replaced with GIGE8, known on camViewer and MEC screens as the beamline camera XRay_Imaging.
- needs mounting.
Motors:
- Thorlabs filter wheel, at the Imaging Spot Opal 4K.
- XTCS
- Newport rotational stage
- "Dumb" filter wheel
Items originally listed but will be needed later for X523
Note: this was my understanding from Eric earlier this week, also see comment below on 25 July.
- e- spectrometer Opal 4K
- thomson parabola Opal 4K
Items originally listed but no longer be used
- XRD ePix10K
- alignment camera 1
- alignment camera 2
- alignment probe