DO NOT FOLLOW THIS PAGE! - Go here instead: How to use the gas jets!
Updated for all DPS pumps being installed, but no apertures except for the holey upstream window.
...
H2 gas - http://physics-elog.slac.stanford.edu/facetelog/show.jsp?dir=/2022/28/12.07&pos=2022-07-12T22:12:49
He gas -
DO NOT FOLLOW THIS PAGE! - Go here instead: How to use the gas jets!
How to set up DPS:
- Follow the gas jet how to page to get the gas jets ready: OBSOLETE - How to use gas jet
- Use the plot above to chose the max backing pressure and rep rate
- Ensure both US-DPS and DS-DPS pumps are running and operating as normal. Also check VPIO:LI20:3164 to ensure the ion pump is on.
- Open the LI20 Vacuum panel, and then open the "DPS full schematic..." panel from the button near center of the page.
- The image below shows a fully functional DPS system:
- Start a strip tool and load the file: DPS_Gasjet_Pressures.stp
- Fire the gas jet once and watch the strip chart.
- VGCC:LI20:3108:US4 should stay below 1e-9 Torr
- VGCC:LI20:3291:DS2 should stay below 1e-5 Torr
- VGCC:LI20:3073 should see minimal change and stay below 5e-8 Torr
- Fire the gas jet for a minute or so and watch the strip chart.
- If all continues to look good then you are good to fire at will.
...