Page History

...

To activate all the links and then check which one reads back to True when reading the variables. There The channel mapping between the flange boards and the RTM has been performed on 8th April 2021 and is summarised here:
Flange Board to RTM Slow Control Channel Mapping

Setting on the Hybrids

In Variables tab navigate to the FebArray→FebCore→FebConfig and HybridPwrEn the 0 and 1 (the power supply will not be able to sustain 3 hybrids, but should be OK for 2). 
After turning on the Hybrids, load the configuration again to be sure you are sending the right config to them. 

...