Page History

...

• ATCA shelf and COB connected to:  rdusr219
• Shelf name, IP: lbne1_0102,192.168.1.254
• RCE SDK path:  /afs/slac.stanford.edu/g/cci/volumes/vol1/sdimages/sdk/current (To get env: source /afs/slac.stanford.edu/g/cci/volumes/vol1/sdimages/sdk/V3.3.0/i86-linux-64/tools/envs-sdk.sh)
• RCE Soft/Firmware path:  /u1/hps/heavy-photon-daq
  • https://github.com/slaclab/heavy-photon-daq/releases/tag/release-4.1-run2016
• The HPS COB is in ATCA slot #2; slot #1 is used by other groups.
• DHPC server config: /u1/dhcp/dnsmasq.local.conf      (restart server with:  sudo service restart dnsmasq)

Before starting working make sure that the heatsink of the FEB is facing upward and the fan is pointing to it. If the FEB overheats it will reset itself (you will see all the leds halfway up).

Start working/developing:

...

In Variables tab navigate to the FebArray→FebCore→FebConfig and HybridPwrEn the 0 and 1 (the power supply might will not be able to sustain 3 hybrids, but should be OK for 2). 
After turning on the Hybrids, load the configuration again to be sure you are sending the right config to them. 

Sending reset commands to the Hybrids

...