Page History

...

Recovering from errors:  restarting AMI (the client)

n In XPP or XCS use the "startami" command. This will start a second client if you are not on the main DAQ machine and it will restart the DAQ AMI client if run on the main DAQ machine (after asking for confirmation, so you will need to use a terminal). Should the server side by unhappy, you will need to restart the DAQ.

...

Ami does not work: the DAQ is fine after a restart, but I see no updates in ami

Make sure that all dss nodes are selected. If you needed to take a node out due to problems, you need to edit the <hutch>.cnf file. You can use "serverStat <ip>" to get the name for the node that causes a problem and then edit the list of dss_nodes to exclude this node. If the problematic node is the last one, you might see that you have to reselect the Bld upon a restart. This means that the DAQ will make you allocate twice (the first time it'll fail with a complaint about a Bld change).

The DAQ shows an "NO CONNECT" in procStat: 

...