Page History
...
| xpptut15 starting run number | Data origin | Comments |
|---|---|---|
| AMO | ||
| 290 | amoc0113 217,219 | see run 280 notes |
| 280 | amoi0216 32,34, | (from Timur Osipov) if I remember it correctly there were two acqires boards (1 and 2?) one broken into 4 channels and the second one just one (or two) channel. The one with 4 channels would be the coordinates for the square delay-line (0 - x1, 1 - x2, 2 - y1, 3 - y2), the other one, with the fewer channels, should be the MCP - TOF channel for the delay line. As for the phosphor screen detector the files from the commissioning of the LAMP (amoc0113) should work - runs 217, 219, 220 each is a couple minutes long with opal images of the phosphor detector. |
| 390 | amod3814, 85 | (from Timur Osipov) HEX anode data: amod3814, runs 85, 88, 90, etc. any decently sized files. Channel assignments including ACQIRIS: PINOUT |
| 340 | amo06516 10,15,19 | pnccd flat-field data (1.74 keV photons from Si k-alpha) |
| 350 | amo01616 125 | (From Alex Reid) Andor camera: Portable X-ray Spectrometer RIXS measurement on CoO, grating in 2nd order, beam energy 780 eV. Andor only read out every 7000 events or so. |
| 360 | amo01616 20 | (From Alex Reid) Emission spectra on Cu measured using the SXR portable spectrometer with Andor detector in full vertical binning mode (120 Hz readout rate) |
| 310 | amol9416 272 | long gain 6 dark for front pnCCD |
| CXI | ||
| 101,102,124 | cxii0314 | xtcav: 101: lasing off, 102: dark, 124: lasing on |
| 270 | cxi06216 22 | crystallography run |
| 380 | cxilp9915 162 | (From TJ Lane) dark run contains two CSPAD cameras (front/back aka DS1/DSD) in a single datastream at CXI |
| 370 | cxilp7315 21 | (From Sebatien Boutet) Two laser flash data for jet speed measurement using Opal1K camera at 120Hz. Also contains 120Hz cspad. |
| 580 | cxilw5019 248 thru 250 | (Requested by Mark Hunter) Lysozyme data on jungfrau4M detector |
| 610 | cxilu9218 12 | SF6 geometry calibration data on jungfrau4M detector |
| MEC | ||
| 460 | mec70013 454 | two princetons PI-MTE with weak XRTS signal. Also has Opals and cspads. |
| 470 | meco1416 250, 256 | PCI experiment, images here from the PI-PIXIS camera. run 470: 10 dark images, run 471: images with X-ray beam and fringes |
| 480 | mecls3115 157 thru 168 | data of optical beam (long pulse) on OPAL camera. run 489 is good: it has some images with different camera positions and ~20 events. |
| 500 | mecdaq115 71, 72 | data of standard configuration, with 3 quads and 2 140k. run 500: calibration data on LaB6, at 7.2keV. run 501: calibration data on CeO2 at 7.2keV |
| 510 | mecx24215 72, 121 | run 510: images on our Peter Optique with the Neo. run 511: data on both the IPM3, GMD and PIP diode (MEC-TCTR-DI-01:FEX) behind the chamber |
| MFX | ||
| 430 | mfx11116 664, 677 | High and lower-flux Jungfrau 1Megapixel attenuation scans |
| 410 | mfx11116 691,694 | Jungfrau 0.5M data |
| 550 | mfxx45919 9-18 | Scattering from water droplets on ePix10k |
| 570 | mfxx45919 80-85 | Protein crystal scattering from droplets on ePix10k |
| 590 | meclx9920 634 | MecTargetChamber.0:Epix10kaQuad.0/1/2/3 |
| SXR | ||
| 520 | sxrx21715 191 | Saturated digitizer data |
| 450 | sxrx20915 40,64 | "front" pnCCD runs in gain 5 from Phil Hart. run 40: dark. run 64: Fe55 flat-field data |
| 440 | sxrx21715, 193 | both acqiris and new high speed digitizer waveforms excited by x-rays |
| 420 | sxrx24615 | Timetool data (spatial) |
| 400 | sxri0215, 155 | SXR time resolved XAS scan using FCCD detector in full vertical binning mode with MCP I0. |
| 330 | sxr82112 197 | Practice encoder data for determining pump-probe time (but no extra time-tool information) |
| XCS | ||
| 260 | xcs01116 81,82,83,120 | epix100: 81(dark), 82,83(vonHamos), 120(speckle) |
| XPP | ||
| 54,59 | XPP test DAQ Runs | 59 contains slow epics data |
| 140 | xppi0813 75-85,87 | 87 is dark, also has timetool epics values |
| 160 | xppc0114 287 | |
| 170 | xppc0115 270 | |
| 180 | xppf2115 | 189,190,192, detector is cspad 140k, data are "samr" scans. |
| 190 | xpp72213 324,300 | detector is cspad 140k, data are most likely delay scans. |
| 200 | xppd0115 375,366 | 366 is dark, 375 is delay scan, detector is a cspad 140k. |
| 210 | xppi3815 224,225 | ccmE_vernier scan, detector is a diode on the end station IPM (diodeU), channel3. A 140k is used for the spectrometer. |
| 220 | xppi3815 100-104 | delay scans. |
| 230 | xpph4915 17 | |
| 240 | xppc0115 328,335 | 328 is rayonix with 2x2 binning, 335 has 10x10 |
| 250 | xpp02016 225,272,300 | New delay scan implementation |
| 320 | xppl4416 283,284 | XPP cspad data and shows powder rings. LaB6 is the sample. |
| 600 | xppx53620 74 | |
| MISC | ||
| 300 | diamcc14 920,921,922 | xtcav: dark,lasing-off,lasing-on xtcav. s00 renamed to s80 |
| 530 | detdaq17 256 (modified! to fix incorrect detid's) | Jungfrau 4M. NOTE: actual data was copied from files with "fixed up" detid's in /reg/d/psdm/det/detdaq17/scratch/philiph/jungfrau/ASC/e968-r1256-s00-c00.xtc /reg/d/psdm/det/detdaq17/scratch/philiph/jungfrau/ASC/e968-r1256-s01-c00.xtc |
| 540 | xcsx35617 421 | Epix10ka2M dark run |
...
Overview
Content Tools