Page History

...

Run 5 DSD metrology,image, configuration

Image Removed

Run 5 XPP (solid plate) metrology for Mar 2012: spreadsheet, description

• Chris writes, "Here is the metrology for the camera on the new baseplate. All sensors locations are
  relative to the lower, left corner of quadrant 3. Within  each quadrant, I measured the sensor
  corners starting form the lower left corner of each sensor and then moved clockwise around
  the chip.
• With the new mechanical package doing this by quadrants doesn't make sense. In the future, it
  might be better to simply organize the metrology by vertical columns.
• The 2x2 module numbering is also attached. It's the same as last time except two modules were
  swapped."
  Image Added

See Mikhail's alignment page, also see here.