The detector locations within the target chamber are marked on this diagram:
Image Added
Detector Number | Type | Function | In DAQ? | Notes | Cabled? | Running? | Comments |
---|
1 | ePix100a | XRTS | Yes | in-vac | NW flange | Yes | ePix 0 |
2 | ePix100a | XTCS | Yes | in-vac | Yes | Yes | ePix 1 |
3 | ePix10k | XRD | Yes | in-vac |
|
|
|
4 | opal 2K | e- spectrometer | Yes | in-air |
4 | thomson parabola | Yes | Yes | opal4_electron_spectrometer |
5 | opal 4K | Thomson Parabola | Yes | in-air |
5 | near-fieldYes | Yes | opal3_thomson_parabola |
6 | opal 2K | NF/FF | Yes | in-air |
6 | imaging | Yes | Yes | opal1_nf_ff Replaced 1K with 2K. |
7 | opal 4K | Imaging spot | Yes | in-air |
7 | time tool | Yes | Yes | opal2_focus_img |
8 | opal 4K | Time Tool | Yes | in-air |
8 | ePix10k | EMP; backgroundvac9air | Yes | Yes | zyla_xray_east |
10 | gigE POE | replacement for GIGE4 | No | in-air, |
TBD10using old GIGE-MEC-CAM08 (Mako G-032B POE) | Yes | Yes | Now known as the beamline camera "XRay_Imaging" |
11 | gigE POE | SPL_TC_alignment | No | in-air, using old GIGE-MEC- |
CAM10 11 | Yes | Yes | It does run well. From time to time, it 'freezes' such that we have to start/stop again. Nothing serious. The camera works well for its purpose! |
12 | gigE POE | 1st alignment camera
| No | in-air, Mako G-032B POE, TBD |
12for wire alignment |
|
| Do we still need this? |
13 | gigE POE | 2nd alignment camera
| No | in-air, Mako G-032B POE, TBD for wire alignment |
|
| Do we still need this? |
14 | contactless probe | alignment
| No | in-vac, TBD, need only the laptop to be accessible remotely |
|
| Do we still need this? |