...
Step 6: Find the power switch on the back of the controller and power off for a few seconds, then turn back on. Ensure that it powers off completely by checking the front panel
Step 7: Ensure that the controller is not reporting a failure or alarm indicator after it turns back on and finishes the initialization, which takes about 20 seconds.
Step 8: Ensure the controller is in remote mode. The indicator light beside "Remote" on the column of status lights should illuminated. If it is not, then press and hold the "Local/Remote" button on the front panel until the "Remote" status indicator comes on (this should take only a few seconds).
- Note: You will almost certainly not have to do this
Step 9: At this point, if the failure has been cleared, the pump should be able to be restarted as described in Restarting DPS pumps.
...
DS-DPS controllers at penetration 20-12:
US-DPS controllers at penetration 20-10:
Power cycling roughing pumps using a breaker
...