...
This will open the device (xc7a200t_0). Right-click the device and choose Add configuration Configuration Memory device:
In the window that opens specify the memory device to be mt25ql256-spi-x1_x2_x4:
Accept the prompt to start programming:
In the window that opens up select which image you want to flash onto the detector (different for LCLS-I and LCLS-II):
The image you want to specify for LCLS-I can be downloaded here:
The one you want for LCLS-II can be downloaded here:
Epix100aGen2-0xEA020008-20211206091023-ruckman-cdd8531.mcs
After downloading the relevant image, give the path in the configuration file box:
and press ok twice to start programming:
After the flashing has been done, the following message should be seen:
After this, close down the software, disconnect and reassemble detector and you are good to go.
The firmware images provided above is valid at the time of writing this page. If new version of the firmware becomes available the following page will instruct on how the get a hold of them, and also provides information such as how to check which firmware version is on the camera:
Firmware version tracking for ePix analog detectors