...

• Remove remaining dependencies on legacy Matlab2012 & "matlab model" code
• Remove instances of direct use of LabCA - move everything over to using PV class in readiness for implementation of PVA
• Beam stay clear plot vs Z (beam aperture vs Z, or acceptance vs delta E)

LEM

• write L1-L3 design phases to PVs
• ignore CQs/SQs when propagating twins parameters. (BMAG plot)
• flag "matching quads" and handle separately when "Lem to model"
• fix BACT=0 causing NaNs in BMAG propagation

...

• tie DL10 set point directly to LLRF control (switch off "slow FB" on RF controller when FB on and vice-versa, increase gain)
• Implement full PID controller coefficients to each feedback, setup and test and include P or PID as option (at least for DL10)
• Implement use of LI17 fast phase shifters for BC20 feedback through SCP multiknob controls
• Auto-adjust gains for changes in beam rate
• Add FFS transverse feedback

MDL Feedforward

Wirescans

• Wire scanner GUI not set wire speed to such a low speed after a scan that the following scan fails if you change planes for IPWS1. 

S20 Config

Orphaned/Unknown Tasks

...