...
Info | ||
---|---|---|
| ||
- Spatial overlap
- move to target
- move to target
Code Block | ||||||
---|---|---|---|---|---|---|
| ||||||
op.move_to_target(config="coliner", frame_cfg=[1, "F1", 1, "F2", 1, "F3"], frame=2, target="A2") |
...
- send drive at low power to check overlap
Code Block | ||||||
---|---|---|---|---|---|---|
| ||||||
op.HWPon("all", set_T=0) |
- move hexapod X to confirm overlap of both set of beams and have them centered on X-ray cross at (342, 561)
- then align the VISAR Z focus to make sure the image is round and sharp (could be set to the value by using the right equation as well)
- Take a reference
Code Block | ||||||
---|---|---|---|---|---|---|
| ||||||
op.ref_only(
xray_trans=0.2,
xray_num=5,
shutters=False,
dark=0,
daq_end=True,
calibrant="",
rate=1,
visar=True,
save=True,
slow_cam=False
) |
- Take a shot
Code Block language py theme RDark linenumbers true op.optical_shot( shutter_close=[1, 2, 3, 4, 5, 6], lpl_ener=0.3, timing=5.0e-9 xray_trans=1, xray_threshold=0.2, save=True, daq_end=True, auto_trig=True, auto_charge=True, visar=True, debug=False, ps_opt=True )
- Saisissez votre tâche ici, en utilisant « @ » pour l'attribution à un utilisateur et « // » pour sélectionner une date d'échéance