...
Note (20 October): Ariana will talk with XPP about air-side cables to the Talbot stage
From Eric on LCLS coordinate systems:
- X=N-S
Z=E-W
Y=vertical
X+ = north
Z+ = west
Y+ = top - But, to map this out, you need to change the 'polarity' of the stage and potentially add offsets, which is a pain if we don't keep a good log of these values, so these days, we just don't care what is X or Z. Y is definitely vertical though. I hope we can fix the X/Z part once the cable management project is further along.
| Stage | IOC | PV | Cabling | Parameter Manager Config | Status |
|---|---|---|---|---|---|
Talbot: Micos PLS-85 #1 | ioc-mec-usrppl-ims | MEC:USR:MMS:24 | To PR60 patch panel Need cable | MEC/PLS-85 In-Air | |
Talbot: Micos PLS-85 #2 | ioc-mec-usrppl-ims | MEC:USR:MMS:25 | To PR60 patch panel Need cable | MEC/PLS-85 In-Air | |
Talbot: Newport TBD | ioc-mec-ppl-xps3 | MEC:PPL:MMN:23 |
Nope - need to remove. It is DB15 (not DB25) on stage side. | Newport | |
East Lens GHIJ: XYZ | ioc-mec-ppl-xps3 | MEC:PPL:MMN:[17-19] | Using XPS3 #1-#3 cables, Flange B *1 - *3. | Newport | Connected and referenced. |
West Lens ABEF: XYZ | ioc-mec-ppl-xps3 | MEC:PPL:MMN:[20-22] | Using XPS3 #4-#6 cables, Flange B *4 - *6. | Newport | Connected and referenced. |
VISAR Lens: XYZ | ioc-mec-ppl-xps2 | MEC:PPL:MMN:[09-11] | XPS2 #1-#3 cables come into bottom SW flange. | Newport | Need to check if cables are long enough (lens is mounted on North side). |
...