Page History

...

•  Remove DC/DC monitor on digital board
•  Check 24V to 1.8V (LT8648S) if it works at 30A
•  Extend analog-digital connector from 30 to 40 pin
•  Replace LT1764 with LT3083 for simpler paralleling circuitry (see power graph)?
•  TPSM5D1806 does not work for 6V to 5.5V as a pre-LDO regulator!
  •  For 5.5V output, the minimum input voltage is 9.6V. See Table 7-3 in datasheet.
  •  Change first-stage converter to output 5.5V/5.0V instead of 6V?
    
    •  Second-stage LMZ31520 (Vout=0.85V) should be OK
    •  Second-stage TPSM5D1806 (Vout=1.8V and 0.9V) should be OK
    •  Changed first-stage converter to 5.0V on digital board now
    •  Do the same on the analog board?
•  Do we have the CML current consumption numbers?
  •  Gang is saying around 20mA (15mA + 30% LVT) per ASIC TX Transceiver (for all frequencies). ASIC RX consumption is negligible 
  •  Update power estimation table with these numbers
•  Request components for Altium library (see Altium Missing Components section)
  •  Connectors have been requested on 2023-08-28
  •  Other ICs
  •  Passives
    •  Resistors
  •  Transceiver
    •  Compare with the layout done in PADS after to make sure it's correct orientation

...