- Route +6V or +24V between analog and digital board?
- If +6V: All first-stage converters (LT8648S) must be on one the board with the input TFM connector
- +24V between boards
- For the 0.6V sink:
- On which board does the power connector (TFM) go and which type (TFM-112, TFM-115, etc)? (update Connectors section)
- TFM-113-02-L-DH was used on the ePixHR250M_2x2_Camera
- Analog board
- Use FPGA transceivers for clocking the ASICs?
- Yes
- One per ASIC?
- Yes
- I think one per ASIC is the best solution. Is there any reason why we should go for a clock splitter?
- Probably no unless we run out of connector pins
- Does the digital board need the analog ground (AGND)? (see 100kfps DAQ support system)
- Will have it anyway since the TFM power connector is on the digital board
|