...
- box 3
- Camera Mode: choose trigger or free run. "Sync In 1" is the trigger.
- switch between 10Hz and single shot: in MEC Home> EVR > New MEC LAS EVR > Front Panel B change to 182 (single shot) from 43 (10Hz)
- Gain: gain is an electronic amplification of the video signal. It adds more voltage to the pixels on your imager (CCD or CMOS) causing them to amplify their intensity and therefore brighten your image. This voltage increase is measured in decibels (dB) and is calculated using this equation: Gain (in dB) = 20 x log(Voltage Out / Voltage In). We usually choose 0 for linear intensity. For small signal you can use higher number.
- Aquisition time: 0.001 sec is good. You might not catch the laser pulse when set <0.001sec.
