First you will need the iepm-bw source code. Typically this is obtained from SLAC by an email request to cottrell@slac.stanford.edu. He will tar up the entire v3src directory, below are the commands he will probably use:>cd $bandsrc
>tar -cvf v3src .tar
>gzip -c v3src.tar /tmp/v3src.tar.gz
>ls -l /tmp/v3src.tar.gz
rw-rr- 1 cottrell sf 125632972 May 17 12:34 /tmp/v3src.tar.gz
>rm v3src.tarcp /tmp/v3
>mv /tmp/v3src.tar.gz ./
>ls -l v3src.tar.gz
rw-rr- 1 cottrell sf 125632972 May 17 12:34 v3src.tar.gz
>cd /afs/slac/public/users/cottrell
>cp $bandsrc/v3src.tar.gz ./
This requires a lot of disk space (e.g. v3src.tar is ~ 180MBytes). It creates a file $bandsrc/v3src.tar.gz which is probably too big to email so it is made available by anonymous ftp. To access it use:>ftp ftp.slac.stanford.edu
Connected to ftp.slac.stanford.edu (134.79.18.30).
220-====================================================================
220-By using this system you expressly consent to the terms and
...220 FTP server ready.
Name (ftp.slac.stanford.edu:cottrell): anonymous331 Anonymous login ok, send your complete email address as your password.
Password:
230-====================================================================
230-
230-Stanford Linear Accelerator Center Anonymous FTP Server
230-
230-====================================================================...
ftp> binary
200 Type set to I
ftp>cd users/cottrell
ftp> ls
227 Entering Passive Mode (134,79,18,30,188,42).
150 Opening ASCII mode data connection for file list
dr-xr-xr-x 2 ftp ftp 4096 May 17 19:45 .
dr-xr-xr-x 2 ftp ftp 4096 May 14 18:21 ..
rrr- 1 ftp ftp 335 Oct 5 2001 identity.pub
rrr- 1 ftp ftp 304 Feb 9 1996 pgp.publickey
rrr- 1 ftp ftp 125632972 May 17 19:45 v3src.tar.gz
226 Transfer complete.ftp> get v3src.tar.gz
local: v3src.tar.gz remote: v3src.tar.gz
227 Entering Passive Mode (134,79,18,30,188,44).
150 Opening BINARY mode data connection for v3src.tar.gz (125632972 bytes)
226 Transfer complete.
125632972 bytes received in 28.4 secs (4.3e+03 Kbytes/sec)
ftp>quit
>
You will need to unzip and detar the file using: tar -xzvf v3src.tar.gz
Currently there is no automated way to install the IEPM-BW monitoring kit on a host. Here are the steps which should be followed, in order, to install the monitoring host software.This assumes that the requirements for hardware and software configuration have been met. Note that if the default account 'iepm' with home directory '/home/iepm' is used, the source directory '/home/iepm/v3src' is used for the source, '/home/iepm/mysql' is used for the data base, then much of the installation can be done by cutting and pasting from this documentation.
...