Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

28 October 2022:

  • All detectors in this table are operational.
  • YAG cameras verified:
    • YAG0
    • YAG1
    • YAG3
    • YAG4 (new, by Zyla)

20 October 2022: Zyla update.

  • The camera was completely disconnected.
  • All connections remade except for the other end of the DB15 cable (power...)
    • Will look for this during housekeeping, searched multiple areas inn the hutch today.

19 October 2022: Resurvey status.

  • Xray_imaging and SPL_TC_alignment gigEs operating.
  • Verified operation of YAG1 and the SPL/Compressor gigEs (CompInNF/FF, CompOutNF/FF) not listed here.
  • All 4 Opals and the ePix100a at XTCS are running.
  • The Zyla is not appearing in the DAQ, will reset today.

The detector locations within the target chamber are marked on this diagram:

Image Removed

1st alignment camera

Detector NumberTypeFunctionIn DAQ?NotesCabled?Running?Comments
1ePix100aXRTSYesin-vacNW flangeYes

ePix 0

Not usable at these intensities (>1019 ?)

2ePix100aXTCSYesin-vacYesYes

ePix 1.

3ePix10kXRDYesin-vac

4opal 2Ke- spectrometerYesin-airYesYesopal4_electron_spectrometer
5opal 4KThomson ParabolaYesin-airYesYes

opal3_thomson_parabola

Not used for L-10008.

6opal 2KNF/FFYesin-airYesYes

opal1_nf_ff

Replaced 1K with 2K.

7opal 4KImaging spotYesin-air

Yes

Yes

opal2_focus_img

8opal 4KTime ToolYesin-airYesYesopal7_timetool
9ZylaMXIYesin-airYesYes

zyla_xray_east

Restart procedure at Zyla and iStar confluence page.

Host is daq-mec-cam02.

10gigE POE

replacement for GIGE4

Noin-air, using old GIGE-MEC-CAM08 (Mako G-032B POE)YesYes

Now known as the beamline camera "XRay_Imaging"

11gigE POESPL_TC_alignmentNoin-air, using old GIGE-MEC-CAM07 (Mako G-032B POE)YesYesIt does run well. From time to time, it 'freezes' such that we have to start/stop again. Nothing serious. The camera works well for its purpose! 
12gigE POENoin-air, Mako G-032B POE, TBD for wire alignmentDo we still need this?13gigE POE

2nd alignment camera

Noin-air, Mako G-032B POE, TBD for wire alignmentDo we still need this?14contactless probe

alignment

Noin-vac, TBD, need only the laptop to be accessible remotelyDo we still need this?