...
- Follow the gas jet how to page to get the gas jets ready: How to use gas jet
- Use the plot above to chose the max backing pressure and rep rate
- Ensure both US-DPS and DS-DPS pumps are running and operating as normal. Also check VPIO:LI20:3164 to ensure the ion pump is on.
- Open the LI20 Vacuum panel, and then open the "DPS full checmatic..." panel
- The image below shows a fully functional DPS system:
- Start a strip tool and load the file: DPS_Gasjet_Pressures.stp
Image of the strip shart - Fire the gas jet once and watch the strip chart.
- VGCC:LI20:3108:US4 should stay below 1e-9 Torr
- VGCC:LI20:3291:DS2 should stay below 1e-5 Torr
- VGCC:LI20:3073 should see minimal change and stay below 5e-8 Torr
- Fire the gas jet for a minute or so and watch the strip chart.
- If all continues to look good then you are good to fire at will.
...