...
- Controls found on CXI home > Detectors tab
- Documentation and Troubleshooting:There is a boot-up procedure:
- takepeds & makepeds:
- <todo>
- ‘restartdaq’ (no ‘startdaq’ command)
- DAQ Control Window: Edit>EVR>event codes>
- Event codes: make rate faster by changing to 120Hz
- Event code allocations: is an overview of event codes and their usage
- For sequencer:
- Trigger to 187
- Change 187 Type to readout
- Command adds it to the datastream
- Event codes: make rate faster by changing to 120Hz
Event definition – 10Hz – CuHTH (T1, HXR 10Hz).
Beam at 10Hz –
...
- Configure DAQ
- takepeds
- makepeds -u <username> -r <run #> -q ffbh3q
- (If missing geometry) makepeds -u <username> -r <run #> -g cxic00120
DAQ
- Use 'restartdaq' to open the daq (there's no 'startdaq' command)
- Event Codes / Timing
- Change on the DAQ Control Window: Edit>EVR>Event Codes
- Set one code to 'Readout' to define when the DAQ records data
- Set codes to 'Command' to have their states for each shot recorded in the data
- Event codes:
- 40 = 120Hz (Default)
- 137 = Every HXR Beam (removes SXR shots and BYKIK)
- 43 = 10Hz
- Event Codes Documentation
- To record only when the sequencer fires, set the DAQ to readout on 187 and put 187 in the sequencer
- Change on the DAQ Control Window: Edit>EVR>Event Codes
AMI
- Will automatically open with the DAQ
- If you need to restart it or open a second viewer, use 'startami'