...

Powercycled cmp011 again.  After resetting the XPM link (toggled XpmMiniTiming/ConfigLCLS2Timing and hit TxPhyReset) I can configure.  Back in the mode where we get 100% deadtime, but I can get transitions and a few events through by doing Blowoff/ClearReadout.

Tried increasing the TriggerPulseWidth to 100us (was 0.092us?) but doesn't help with deadtime:

Image Added

This TxOpCodeCount under Hsio→PgpMon[0] seems to only increase with L1Accepts.  We are getting far fewer of these than the L1Accept rate says we should.  Suggests we're dropping camera frames?

Image Added

Not Understood Failure Modes

...