Page History

...

• send escape right away after powering up
• linkmode: medium
• datamode: 8bit
• framemode: our camera only gives a line valid (indication that there is valid data) so we need to set to "line"
• tapcount: our camera sends 4 bytes where it could send 6
• dataen: enables the data block (leave false until able to receive data)
• baudrate: 9600
• use sendGCP to test serial link is working (output should appear on terminal)
• swcontrolvalue/swcontrolen: bits for hardware vs software trigger (0/0 internal trigger)
• dataen: enables the data block (leave false until able to receive data)
• running: status bit (am I getting frames from camera)
• dropcount: 3 channels misaligned (errors)
• have to set both sender/receiver to "medium".  send these TLC strings to the camera:
• CLM 1 (cameralink medium mode)
• SVM 1 (test pattern ramp)
• SSF 1 (software trigger rate 1Hz, although seems to read back as 6Hz? and 2 reads back as 12Hz?)

...