...
- Power up board at 12 V and 1.7 A current limit.
- Attach a Xilinx dongle to J32.
- Run impact.
- Right click on FPGA icon and select "Add BPI/SPI flash".
- The file to download is HsioTest_00000003.mcs .
- Select BPI PROM 28F00AP30.
- Right click on the prom icon and select program.
- After programming you can power down the board and quit impact.
- Install the following test devices on the board:
- Loopback SFP modules in SFP0 and SFP1.
- A loopback QSFP module in QSFP0.
- 2 SMA cables: One between TXP and RXP, one between TXM and RXM.
- 2 header test boards in P2 and P3.
- 1 zone-3 test board.
- The DTM test module.
- The TTC module that belongs to this particular board.
- Attach a USB cable to J30 (GP).
- Power up the board, again at 12 V and 1.7A.
- Bring up the serial connection at 115200 Baud with logging of the output to file.
- Push the COLD-BOOT button on the HSIO and follow the instructions on the screen for testing.Perform both the HSIO and the DTM test.
- If HSIO tests pass, proceed to DTM test.
- Move JTAG cable to DTM JTAG module (bottom of board).
- Reset cable and load DTMtest_00000001.bit into DTM FPGA.
- Follow on screen instructions.
- Once the test finishes successfully, quit the serial connection.
- Upload logfile (after renaming it) file to database page created above (scan QR code to find page).
...