Page History
...
- Chris writes, "Here is the metrology for the camera on the new baseplate. All sensors locations are
relative to the lower, left corner of quadrant 3. Within each quadrant, I measured the sensor
corners starting form the lower left corner of each sensor and then moved clockwise around
the chip. - With the new mechanical package doing this by quadrants doesn't make sense. In the future, it
might be better to simply organize the metrology by vertical columns. - The 2x2 module numbering is also attached. It's the same as last time except two modules were
swapped."
- The metrology was done upside down, so q2->q0 etc and x->177457-x, y->185867-y
- photograph
Overview
Content Tools