Wiki Markup |
---|
# Default "accelerator" is loaded at startup. |
...
If you want to load a test model, Use Accelerator->Load Accelerator... |
...
# Accelerator->Sequences is in fact really for automatic calculation of bump knobs |
...
# to create a knob, just do the following: |
...
## Optionally, create a group |
...
(+). ## Create a knob (+) ## Add devices: ### Do this "by hand" if you know the PV. Eg YCOR:IN20:492:BDES |
...
### Do this by "drilldown" (which uses physics name). In the Editor: |
...
#### Select a model sequence: Eg BXG TO BX01. Note that sequences are in alphabetical order. That is on the fix list. |
...
#### Select a device "type". Note that the type names given are: |
...
1) SNS type names, which themselves use >1 name eg hcorr == dch == horrzcorr => X correctors. |
...
2) and also flattened hierarchy of types, eg type "dipole" includes hcorr and vcorr. |
...
#### Select a device name, by "physics name". |
...
#### Select FieldSet (not FieldRB). (issue: FieldRB should not be offered). |
...
- Design Offset 3 (default) magnets - works (4 magnet doesn't work!)
- Design Angle 5 (default) magnets - works
- Live Offset 3 - works
- Live Angle 5 works - works
...
## Or calculate bump knobs
### Select a section of contiguous sequence of sections (a "combo sequence") Accelerator->Sequences
BXG TO BX01 - BX01 to BX02 works.
### Knobs->{Make Horizontal Bumps | Make vertical bumps} *Make Horizontal Bumps* (Make Vertical Doesn't work, since it seems so many of our correctors are SLC!)
### For Horizontal Bumps: These setups were tested.
#### Design Offset 3 (default) magnets - works (4 magnet doesn't work!)
#### Design Angle 5 (default) magnets - works
#### Live Offset 3 - works
#### Live Angle 5 works - works
### For Vertical Bumps, select sections BXG to BX01 - QM15 to FV2
#### Design Offset 3 (default) magnets - works, but they're mostly SLC magnets.
|