Page History

-# Default "accelerator" is loaded at startup. 
	If you want to load a test model, Use Accelerator->Load Accelerator...
-# Accelerator->Sequences is in fact really for automatic calculation of bump knobs
-# to create a knob, just do the following:
##	Optionally, create a group (+).
##	Create a knob (+)
##        Add devices:
          -### Do this "by hand" if you know the PV. Eg YCOR:IN20:492:BDES
          -### Do this by "drilldown" (which uses physics name). In the Editor:
		-#### Select a model sequence: Eg BXG TO BX01. Note that sequences are in alphabetical order. That is on the fix list.
		-#### Select a device "type". Note that the type names given are:
			1) SNS type names, which themselves use >1 name eg hcorr == dch == horrzcorr => X correctors.
			2) and also flattened hierarchy of types, eg type "dipole" includes hcorr and vcorr.
		-#### Select a device name, by "physics name".
		-#### Select FieldSet (not FieldRB). (issue: FieldRB should not be offered).
##      Or calculate bump knobs
	    -### Select a section of contiguous sequence of sections (a "combo sequence") Accelerator->Sequences
	      BXG TO BX01 - BX01 to BX02 works.
	    -### Knobs->{Make Horizontal Bumps | Make vertical bumps} *Make Horizontal Bumps* (makeMake Vertical Doesn't work, since it seems so many of our correctors are SLC!)
          ###  For Horizontal Bumps: These setups were tested.
		    -#### Design Offset 3 (default) magnets - works  (4 magnet doesn't work!)
		    -#### Design Angle 5 (default) magnets - works
                  -  #### Live Offset 3 - works
		    -#### Live Angle 5 works - works
          ###  For Vertical Bumps, select sections BXG to BX01 - QM15 to FV2
	            -####  Design Offset 3 (default) magnets - works, but they're mostly SLC magnets.