- source ~/scripts/setup_env.sh
- procmgr restart mfx.cnf
- procmgr stop mfx.cnf

- run trigger group6 (change in DAQ:NEHgui)
- daq trigger group2 (change in daq edit)

- epipxhr_pedestal_scan --help
- epixhr_timing_scan --linear lo hi stepsize  (scans on start_ns)
- epixhr_chargeinj_scan

- epixhr_config_scan (for future)

----------Setting timing--------------
- find beam w.r.t evcode40.  Here, start_ns uses evcode40 as the marker
find delay
- then set evcode280(run) and 281(daq) to be delay - 100us(for example)
python seq_epixhr.py --rate 4800 --tgt 0.96e-3  ---  this is rate and daq 
trigger location.. --tgt puts daq trig w.r.t evcode40
- do timing scan again to find beam w.r.t evcode280.  At this point
start_ns will use evcode280 as the marker
---------------------------------------
Example:
1. epixhr_timing_scan --linear 850000 950000 10000 (ns)
2. Find delay to be X
3. python seq_epixhr.py --rate 4800 --tgt 0.8e-3 
4. epixhr_timing_scan --linear 70000 130000 5000

daq   run
120	120    evcode40 (or 281 + 280)
120	2400	evcode40 + evcode280 (--rate 2400)
120	4920	evcode40 + evcode280 (--rate 4920)
360 	2400	evcode1 + evcode280 (--rate 2400)
start_ns is always w.r.t run trigger

 epix10ka_pedestals_calibration -k exp=rixc00221,run=42 -d epixhr
 epix10ka_deploy_constants -k exp=rixc00221,run=42 -d epixhr