Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

The b+MET signature is almost unexplored in ATLAS: b-tag and missing ET are among the most challenging and complex techniques. Expertise in multiple areas is required, which matches well SLAC strengths.

Image Removed

There are several experimental challenges to b+MET analyses:

...

Our group is heavily involved in all these areas is making significant contributions to ATLAS reconstruction software and analysis.

Below there is a list of some of An overview of the b+MET physics analyses being pursued:+Jet+MET topology-based research can be found in the diagram and links below.

Image Added

Top quark cross section measurement in the missing ET + b-jet channel

...

Section
Column
width40%

Column
width60%


The LHC will produce collisions at a rate of 40MHz. The purpose of the trigger system is to reduce the output event storage rate to about 300MB/s or approximately 200Hz.
Since most of the collisions at the LHC center of mass energy will result in non-interesting physics events, such QCD multi-jet production, the main task of the trigger system is to reject QCD events while maintaining high efficiency for low cross section processes like Super-symmetry, Higgs, etc.

The ATLAS trigger consists of three levels: Level 1, which is hardware based, and the high level trigger (HLT) which consists of Level 2, and the Event Filter. The HLT is based on software algorithms that analyze region of interests (RoI) identified by the level 1 trigger. The output rates of the three trigger levels are 75KHZ, 2KHz, 200Hz.

Tagging b-jets at the trigger level can expand the physics reach of ATLAS in many ways: it allows to lower the jet ET threshold to increase the acceptance of interesting physics events containing multiple b-jets (like bbH and ttH ), and can be used to reduce non-b backgrounds and improve the purity of Super-symmetry searches involving b-jets in the ?nal state.
The SLAC group has implemented one of the two ATLAS b-tagging algorithms at level 2 trigger: the Impact Parameter ?2 Probability tagger (IPChi2)

Current and future work involves the optimization of the operational parameters of the algorithm, determination of performance in real data events, on-line and off-line validation, and the investigation of new trigger menus involving b-quarks and missing transverse energy for Super-symmetry searches.

...

Section
Column
width70%

The IPChi2 tagger is based on the impact parameter distribution of mis-tags, which can be derived directly from data and does not require the use of Monte Carlo templates as in the likelihood ratio b-tagger.
For every region of interest selected by the level 1 trigger, the level 2 b-tagging algorithm uses tracks reconstructed by the level 2 trigger, to determine the probability that the RoI originates form the primary vertex. b-jets are identified by chi2 probability cut.

The performance is measured as rejection as a function of efficiency. For instance, for a b-tagging efficiency of 60%, the Level 2 b-tagging algorithm rejection is 4, which means that, on average, only one out of four light quark jets will pass the selection.
link to ATLAS page

b-jet trigger menu

We are working in the design of different trigger chains (set of trigger signatures and operational points at Level 1, Level 2 and Event Filter) optimized for different physics analyses, in particular all hadronic top, and inclusive jet+MET and b+MET searches.

In particular, we are investigating the performance of asymmetric double b-tagging, which consists of requiring one loose and one tight b-tag jets. We have seen that this type of selection improves the rejection (at a same efficiency) compared to the more standard symmetric tagging.

link to ATLAS page

b+MET combined trigger

The SLAC group has proposed a combined b-jet+MET trigger, to be used in physics signatures containing b-jets and missing ET. The missing ET requirement provides an additional handle to reduce the output rate, while maintaining high efficiency for signal events.

We are currently studying the effect of this trigger signature in hadronic top quark final states, and b+MET Super-symmetric events.

link to ATLAS page

Column
width30%